Most Important Things about ecigs you need to Know

·       Never charge your batteries before they are dead. Batteries are dead when the LED flashes immediately every time you attempt to take a puff. If the battery has no charge at all the LED light will not illuminate at all which also indicates it needs to be charged.

·       Always keep your threads clean. Wipe the threads clean on your battery, atomizer, and cartomizers every time you change or refill a cartridge. Not doing this will cause a short resulting in the device no longer working.

·       Never charge your PCC with a battery screwed into the charging slot on PCC.

·       Remove cartomizer from battery before refilling.

·       Always wipe excess liquid off of cartridges and cartomizer threads after refilling.

·       Take long (3 – 6 second), soft puffs to produce the best flavor and vapor

·       Twist cartridges when removing to make them easier to get off atomizer

·       Never use with a dry cartridge or cartomizer. It only takes a few puffs with a dry cartridge to burn up the atomizer.

·       Don’t over-tighten the battery on the atomizer/cartomizer, in the charger or PCC. Screw it in until you feel resistance and that’s tight enough.

·       If the LED light on your battery activates without taking a puff or the atomizer/cartomizer activates by itself when you screw onto battery you have liquid in your battery from over filling the cartridge or the threads on your device are dirty. You can try to remove the liquid from the battery using a can of compressed air by blowing the air into the thread end of the battery. You can also clean the threads on your device with a paper towel to see if it corrects the problem. If the problem still exists you will need to replace the battery. To prevent the issue be sure not to over fill the cartridges and be sure to keep the threads clean on your device.